В вашем примере опять же, блокирует owner. А я писал про транзитные узлы.
И я писал про транзитные узлы. Специально в примере отметил, что рвётся НЕ RPL линк.
Это я понимаю. Но согласно описанию erps блокировка происходит только на узлах "owner" и "neighbor" в сторону друг друга.
Блокировка между owner и neighbor происходит только в статусе кольца IDLE. Если рвётся и восстанавливается не RPL линк, то в статусе Pending он остаётся заблокированным (только с одной стороны)
Доказательство в приложенном вами стандарте:
The following sequence describes the steps in Figure III.2.
A. Stable SF condition.
B. Recovery of link failure.
C. Ethernet ring nodes C and D detect clearing of SF condition, start the guard timer and initiate
the periodical transmission of R-APS (NR) messages on both ring ports. (The guard timer
prevents the reception of R-APS messages.)
D. When the Ethernet ring nodes receive an R-APS (NR) message, the (node ID, BPR) pair of
a receiving ring port is deleted and the RPL owner node starts the WTR timer.
E. When the guard timer expires on Ethernet ring nodes C and D, they may accept the new
R-APS messages that they receive. Ethernet ring node D receives an R-APS (NR) message
with a higher node ID from Ethernet ring node C and unblocks its non-failed ring port.
F. On expiration of the WTR timer, the RPL owner node blocks its end of the RPL, sends an
R-APS (NR, RB) message with the (node ID, BPR) pair and performs the FDB flush.
G. When Ethernet ring node C receives an R-APS (NR, RB) message, it removes the block on
its blocked ring ports and stops sending R-APS (NR) messages. On the other hand, when the
RPL neighbour node A receives an R-APS (NR, RB) message, it blocks its end of the RPL.
In addition to this, Ethernet ring nodes A to F perform the FDB flush when receiving an
R-APS (NR, RB) message due to the node ID and BPR-based mechanism
В пункте "E" говорится, что после истечения guard таймера и перехода кольца в состояние Pending нода D свой порт разблокирует, а нода C оставляет заблокированным. В пунктах F, G говорится, что только после истечения WTR таймера блокируется RPL линк и нода C разблокирует порт, на котором ранее была детектирована авария.