MES3108F. Не работает ERPS
Добавлено: 06 дек 2018 15:43
Добрый день!
На стенде две железки. Соединены двумя линками. Собственно, между ними ERPS. Порты RPL не блокируются. статус кольца INIT.
всё ли верно в конфигурации?
STP выключен, фильтрация БПДУ включена глобально и на портах.
Отличаются только HW версии железок.
конфиг первой железки:
console#sho spanning-tree
*********************************** Process 0 ***********************************
Spanning tree disabled (BPDU filtering) mode RSTP
Default port cost method: long
Loopback guard: Disabled
console#sho run int gi1/0/3
interface gigabitethernet 1/0/3
switchport mode trunk
switchport trunk allowed vlan add 2980-2981
storm-control broadcast enable
storm-control multicast enable
storm-control unknown-unicast enable
spanning-tree disable
spanning-tree bpdu filtering
no lldp transmit
switchport forbidden default-vlan
exit
console#sho run int gi1/0/4
interface gigabitethernet 1/0/4
switchport mode trunk
switchport trunk allowed vlan add 2980-2981
storm-control broadcast enable
storm-control multicast enable
storm-control unknown-unicast enable
spanning-tree disable
spanning-tree bpdu filtering
no lldp transmit
switchport forbidden default-vlan
exit
!
ERPS
erps vlan 2980
port west gigabitethernet1/0/3
port east gigabitethernet1/0/4
rpl west owner
protected vlan add 2981
exit
console#sho erps vlan 2980
R-APS VLAN : 2980
Admin Status : Disabled
West Port : gi1/0/3 (Forwarding)
East Port : gi1/0/4 (Forwarding)
RPL Port : West
RPL Owner : Enabled (Active)
Protected VLANs : 2981
Ring MEL : 1
Holdoff Time : 0 msec
Guard Time : 500 msec
WTR Time : 5 min
Current Ring State : Init
Revertive : Yes
Compatibility with version : 2
console#sho ver
SW version 2.5.47[4a975dcb] ( date 25-Aug-2017 time 17:13:16 )
Boot version 0.0.1.5 ( date 07-Dec-2016 time 08:42:13 )
HW version 02.07
CPLD version 04
конфиг второй железки
console#show spanning-tree
*********************************** Process 0 ***********************************
Spanning tree disabled (BPDU filtering) mode RSTP
Default port cost method: long
Loopback guard: Disabled
console#sho run int gi1/0/3
interface gigabitethernet 1/0/3
switchport mode trunk
switchport trunk allowed vlan add 2980-2981
storm-control broadcast enable
storm-control multicast enable
storm-control unknown-unicast enable
spanning-tree disable
spanning-tree bpdu filtering
no lldp transmit
switchport forbidden default-vlan
exit
!
console#sho run int gi1/0/4
interface gigabitethernet 1/0/4
switchport mode trunk
switchport trunk allowed vlan add 2980-2981
storm-control broadcast enable
storm-control multicast enable
storm-control unknown-unicast enable
spanning-tree disable
spanning-tree bpdu filtering
no lldp transmit
switchport forbidden default-vlan
exit
ERPS
erps vlan 2980
port west gigabitethernet1/0/3
port east gigabitethernet1/0/4
rpl east neighbor
ring enable
protected vlan add 2981
exit
console#sho erps vlan 2980
R-APS VLAN : 2980
Admin Status : Enabled
West Port : gi1/0/3 (Forwarding)
East Port : gi1/0/4 (Forwarding)
RPL Port : East
RPL Owner : Disabled
Protected VLANs : 2981
Ring MEL : 1
Holdoff Time : 0 msec
Guard Time : 500 msec
WTR Time : 5 min
Current Ring State : Init
Revertive : Yes
Compatibility with version : 2
console#sho ver
SW version 2.5.47[4a975dcb] ( date 25-Aug-2017 time 17:13:16 )
Boot version 0.0.1.5 ( date 07-Dec-2016 time 08:42:13 )
HW version 02.05
CPLD version 04
На стенде две железки. Соединены двумя линками. Собственно, между ними ERPS. Порты RPL не блокируются. статус кольца INIT.
всё ли верно в конфигурации?
STP выключен, фильтрация БПДУ включена глобально и на портах.
Отличаются только HW версии железок.
конфиг первой железки:
console#sho spanning-tree
*********************************** Process 0 ***********************************
Spanning tree disabled (BPDU filtering) mode RSTP
Default port cost method: long
Loopback guard: Disabled
console#sho run int gi1/0/3
interface gigabitethernet 1/0/3
switchport mode trunk
switchport trunk allowed vlan add 2980-2981
storm-control broadcast enable
storm-control multicast enable
storm-control unknown-unicast enable
spanning-tree disable
spanning-tree bpdu filtering
no lldp transmit
switchport forbidden default-vlan
exit
console#sho run int gi1/0/4
interface gigabitethernet 1/0/4
switchport mode trunk
switchport trunk allowed vlan add 2980-2981
storm-control broadcast enable
storm-control multicast enable
storm-control unknown-unicast enable
spanning-tree disable
spanning-tree bpdu filtering
no lldp transmit
switchport forbidden default-vlan
exit
!
ERPS
erps vlan 2980
port west gigabitethernet1/0/3
port east gigabitethernet1/0/4
rpl west owner
protected vlan add 2981
exit
console#sho erps vlan 2980
R-APS VLAN : 2980
Admin Status : Disabled
West Port : gi1/0/3 (Forwarding)
East Port : gi1/0/4 (Forwarding)
RPL Port : West
RPL Owner : Enabled (Active)
Protected VLANs : 2981
Ring MEL : 1
Holdoff Time : 0 msec
Guard Time : 500 msec
WTR Time : 5 min
Current Ring State : Init
Revertive : Yes
Compatibility with version : 2
console#sho ver
SW version 2.5.47[4a975dcb] ( date 25-Aug-2017 time 17:13:16 )
Boot version 0.0.1.5 ( date 07-Dec-2016 time 08:42:13 )
HW version 02.07
CPLD version 04
конфиг второй железки
console#show spanning-tree
*********************************** Process 0 ***********************************
Spanning tree disabled (BPDU filtering) mode RSTP
Default port cost method: long
Loopback guard: Disabled
console#sho run int gi1/0/3
interface gigabitethernet 1/0/3
switchport mode trunk
switchport trunk allowed vlan add 2980-2981
storm-control broadcast enable
storm-control multicast enable
storm-control unknown-unicast enable
spanning-tree disable
spanning-tree bpdu filtering
no lldp transmit
switchport forbidden default-vlan
exit
!
console#sho run int gi1/0/4
interface gigabitethernet 1/0/4
switchport mode trunk
switchport trunk allowed vlan add 2980-2981
storm-control broadcast enable
storm-control multicast enable
storm-control unknown-unicast enable
spanning-tree disable
spanning-tree bpdu filtering
no lldp transmit
switchport forbidden default-vlan
exit
ERPS
erps vlan 2980
port west gigabitethernet1/0/3
port east gigabitethernet1/0/4
rpl east neighbor
ring enable
protected vlan add 2981
exit
console#sho erps vlan 2980
R-APS VLAN : 2980
Admin Status : Enabled
West Port : gi1/0/3 (Forwarding)
East Port : gi1/0/4 (Forwarding)
RPL Port : East
RPL Owner : Disabled
Protected VLANs : 2981
Ring MEL : 1
Holdoff Time : 0 msec
Guard Time : 500 msec
WTR Time : 5 min
Current Ring State : Init
Revertive : Yes
Compatibility with version : 2
console#sho ver
SW version 2.5.47[4a975dcb] ( date 25-Aug-2017 time 17:13:16 )
Boot version 0.0.1.5 ( date 07-Dec-2016 time 08:42:13 )
HW version 02.05
CPLD version 04