Элтекс

Hello!
I am using the "bridge over OMCI" configuration, and it is necessary to "blink" one of the ports. Is there such a possibility?
In "profile ports" I see the ability to set the speed and duplex for the copper port, but I do not see the ability to disable it at all, as in other OLTs.
Looking not there?
I expected to see such a command in the "send omci xxxx ...." section, as it is done in other olt, but it is not there:(10.0.0.0.1 192.168.1.254

HiroyuYulin писал(а):Hello!
I am using the "bridge over OMCI" configuration, and it is necessary to "blink" one of the ports. Is there such a possibility?
In "profile ports" I see the ability to set the speed and duplex for the copper port, but I do not see the ability to disable it at all, as in other OLTs.
Looking not there?
I expected to see such a command in the "send omci xxxx ...." section, as it is done in other olt, but it is not there:(

Hello,
This option is unavailable on our OLTs.
You can omit to specify a bridge group for a port through which you do not need to pass traffic of a certain service. In this case, the service on this LAN port will not work.