В этом примере sfp с ddm вставлены: (обратите внимание на media:copper)
Код: Выделить всё
olt(switch)# show interfaces status front-port 1
Interface Status Media Speed Duplex Flow control
front-port 1 up copper auto auto no
olt(switch)# show interfaces status front-port 2
Interface Status Media Speed Duplex Flow control
front-port 2 up copper auto auto no
olt(switch)# show sfp front-port 1
SFP status:
~~~~~~~~~~~
Port Temp [á¦C] Voltage [Volt] Current [mA] RX power [mWatt] TX power [mWatt]
-------------------- --------- -------------- ------------ ---------------- ----------------
front-port 1 63.438 3.3096 24.704 0.0032 0.2408
-------------------- --------- -------------- ------------ ---------------- ----------------
N/A - Not Available, N/S - Not Supported
olt(switch)# show sfp front-port 2
SFP status:
~~~~~~~~~~~
Port Temp [á¦C] Voltage [Volt] Current [mA] RX power [mWatt] TX power [mWatt]
-------------------- --------- -------------- ------------ ---------------- ----------------
front-port 2 57.742 3.3112 27.070 0.0311 0.2518
-------------------- --------- -------------- ------------ ---------------- ----------------
N/A - Not Available, N/S - Not Supported
olt(switch)#
И вообще хотелось бы вывода всех интерфейсов в одной команде по "show interface и show sfp". Иначе их приходится перебирать по очереди.