http://eltex.nsk.ru/support/knowledge/k ... hannel.php
"OLT LTP_3.24.1_issue5_rus.pdf" стр.75
не получается настроить port-channel LACP:
Код: Выделить всё
LTP-4X(switch)(config)# interface port-channel 1
LTP-4X(switch)(config-if)# no shut
LTP-4X(switch)(config-if)# frame-types all
LTP-4X(switch)(config-if)# mode lacp
LTP-4X(switch)(config-if)# ex
LTP-4X(switch)(config)# interface front-port 2 - 3
LTP-4X(switch)(config-if-range)# channel-group port-channel 1
Port front-port 2 add to port-channel 1 error: not ready
Port front-port 3 add to port-channel 1 error: not ready
LTP-4X(switch)(config-if-range)# ex
LTP-4X(switch)(config)# commit
LTP-4X(switch)(config)# Jan 1 00:06:04 LTP-4X switchd: %DISPATCH-EVT: Transmit event <24> to service SERVICE_STP
Jan 1 00:06:04 LTP-4X switchd: %DISPATCH-EVT: Transmit event <24> to service SERVICE PSTATE CHECK
LTP-4X(switch)(config)#
LTP-4X(switch)(config)# interface front-port 2 - 3
LTP-4X(switch)(config-if-range)# channel-group port-channel 1
Port front-port 2 add to port-channel 1 error: not ready
Port front-port 3 add to port-channel 1 error: not ready
LTP-4X(switch)(config-if-range)# ex
LTP-4X(switch)(config)# lacp system-priority 32541
LTP-4X(switch)(config)# port-channel load-balance mac
LTP-4X(switch)(config)# interface front-port 2 - 3
LTP-4X(switch)(config-if-range)# channel-group port-channel 1
Port front-port 2 add to port-channel 1 error: not ready
Port front-port 3 add to port-channel 1 error: not ready
LTP-4X(switch)(config-if-range)# commit
LTP-4X(switch)(config)# Jan 1 00:10:08 LTP-4X switchd: %DISPATCH-EVT: Transmit event <13> to service SERVICE_LACP
LTP-4X(switch)(config)# interface front-port 2 - 3
LTP-4X(switch)(config-if-range)# channel-group port-channel 1
Port front-port 2 add to port-channel 1 error: not ready
Port front-port 3 add to port-channel 1 error: not ready
LTP-4X(switch)(config-if-range)#
LTP-4X(switch)(config-if-range)#
LTP-4X(switch)(config-if-range)# ex
LTP-4X(switch)(config)# interface front-port 2
LTP-4X(switch)(config-if)# channel-group port-channel 1
Port front-port 2 add to port-channel 1 error: not ready
LTP-4X(switch)(config-if)# ex
Также не существует параметров "OLT LTP_3.24.1_issue5_rus.pdf" стр 75 шаг 10 и 11
Код: Выделить всё
LTP-4X(switch)(config)# interface port-channel 1
LTP-4X(switch)(config-if)# ?
help Show available commands
exit Exit from current mode
history Show a list of previously run commands
no Negate a command or set its defaults
shutdown Shut down the selected interface
flow-control Set flow control mode
ip Configure IP services
ingress-filtering Enable VLAN ingress filtering for the port
frame-types Set Acceptable Frame Types for the port
pvid Set port PVID
pup Set port PUP
bridging Configure briging
mode Set aggregation mode
speed Set interface speed
spanning-tree Configure Spanning Tree Protocol for port
LTP-4X(switch)(config-if)# mode ?
lacp Enable Link Aggregation Control Protocol
static Don't use any aggregation control protocol