         __  __                      _ _
        |  \/  | __ _ _ ____   _____| | |
        | |\/| |/ _` | '__\ \ / / _ \ | |
        | |  | | (_| | |   \ V /  __/ | |
        |_|  |_|\__,_|_|    \_/ \___|_|_|
 _   _     ____              _
| | | |   | __ )  ___   ___ | |_
| | | |___|  _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
 \___/    |____/ \___/ \___/ \__|  ** LOADER **
 ** MARVELL BOARD: DB-98DX4122-48G LE (configured)
 ** Linux        - LE/BE support
 ** vxWorks(elf) - LE/BE support


U-Boot 1.1.4 (Aug 26 2019 - 12:41:06) Marvell version: 3.4.9.7

U-Boot code: 01200000 -> 0128FFF0  BSS: -> 012A8400

Soc: 88F6281 A0 (DDR2)
CPU running @ 800Mhz L2 running @ 400Mhz
SysClock = 320Mhz , TClock = 166Mhz

DRAM CAS Latency = 5 tRP = 6 tRAS = 15 tRCD=6
DRAM CS[0] base 0x00000000   size 256MB
DRAM CS[1] base 0x10000000   size 256MB
DRAM Total size 512MB  16bit width
[16384kB@f8000000] Flash: 16 MB
Addresses 27M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (27M - 19M): Done
NAND:try to read bytes: 1 220
NAND device: Manufacturer ID: 0x01, Chip ID: 0xdc (Unknown NAND 512MiB 3,3V 8-bi                                                                                                                                                             t)
Scanning device for bad blocks
512 MB
env_relocate_spec: set flash map to 0
env_relocate_spec: restore flash map to 0

CPU : Marvell Feroceon (Rev 1)
Set ELTEX environment for 1x128 SPI FLASH and 1x4G NAND!
saveenv: set flash map to 0
................................................................
................................................................
................................................................
................................................................

Un-Protected 1 sectors
Erasing Flash...
.
Erased 1 sectors
Writing to Flash... done
................................................................
................................................................
................................................................
................................................................

Protected 1 sectors
saveenv: restore flash map to 0

Streaming disabled
Write allocate disabled


USB 0: host mode
PCI 0: PCI Express Root Complex Interface
PEX interface detected Link X1
Net:   Allowed switch ports:  16 17 18 19 20 21 22 23
egiga0 [PRIME], port16, port17, port18, port19, port20, port21, port22, port23
Type "stop" in 3 sec, to stop autoboot
Time out
## Executing script at 02000000
booting secondary linux

NAND read: device 0 offset 0x3800000, size 0x1000000

Reading data from 0x47ff800 -- 100% complete.
 16777216 bytes read: OK
Addresses 0xf8000000 0xf809ffff are strongly protected.

Loading from NAND 512MiB 3,3V 8-bit, offset 0xc00000
   Image Name:   Linux-2.6.22.18
   Created:      2020-02-07  10:31:44 UTC
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    1369216 Bytes =  1.3 MB
   Load Address: 00008000
   Entry Point:  00008000
** Read error
Saving Environment to Flash...
saveenv: set flash map to 0
................................................................
................................................................
................................................................
................................................................

Un-Protected 1 sectors
Erasing Flash...
.
Erased 1 sectors
Writing to Flash... done
................................................................
................................................................
................................................................
................................................................

Protected 1 sectors
saveenv: restore flash map to 0
booting primary linux

NAND read: device 0 offset 0x1800000, size 0x1000000

Reading data from 0x1d70800 --  34% complete.reading NAND page at offset 0x1d988                                                                                                                                                             00 failed
 16777216 bytes read: ERROR
Saving Environment to Flash...
saveenv: set flash map to 0
................................................................
................................................................
................................................................
................................................................

Un-Protected 1 sectors
Erasing Flash...
.
Erased 1 sectors
Writing to Flash... done
................................................................
................................................................
................................................................
................................................................

Protected 1 sectors
saveenv: restore flash map to 0
