MES 3124F какой командой убрать настройку?
Добавлено: 16 окт 2015 18:58
Код: Выделить всё
#show running-config interfaces GigabitEthernet 0/22
interface gigabitethernet 1/0/22
loopback-detection enable
switchport mode trunk
switchport trunk allowed vlan add 100
load-average 5
optical-transceiver threshold action temperature syslog
optical-transceiver threshold action voltage syslog
optical-transceiver threshold action current syslog
optical-transceiver threshold action output-power syslog
optical-transceiver threshold action input-power syslog
втыкаю команды
Код: Выделить всё
#conf t
(config)#interface GigabitEthernet 0/22
(config-if)#no optical-transceiver threshold action temperature syslog
% Unrecognized command
(config-if)#no optical-transceiver threshold action voltage syslog
% Unrecognized command
(config-if)#no optical-transceiver threshold action current syslog
и т.д. команды не срабатывают
из за этого "кривого" SFP модуля (http://eltex.nsk.ru/forum/viewtopic.php?f=10&t=5436) все логи завалены сообщениями
Код: Выделить всё
#show version
SW version 2.5.40 ( date 20-Jul-2015 time 14:40:04 )
Boot version 0.0.1.2 ( date 12-Dec-2012 time 19:10:41 )
HW version 02.06
CPLD version 03