MES2324 ПО 4.0.13
Добавлено: 12 ноя 2019 22:11
Добрый день!
После прошивки на 4.0.13 при выводе show run получаем такое:
После прошивки на 4.0.13 при выводе show run получаем такое:
Код: Выделить всё
!
errdisable recovery cause loopback-detection
errdisable recovery cause port-security
errdisable recovery cause dot1x-src-address
errdisable recovery cause acl-deny
errdisable recovery cause stp-bpdu-guard
errdisable recovery cause stp-loopback-guard
errdisable recovery cause unidirectional-link
errdisable recovery cause storm-control
errdisable recovery cause l2pt-guard
errdisable recovery cause pvst
TSpecialHandlerC_GetParamValue: CommandID: auto_recovery ParameterID: auto_recovery_cause Enumeration Index: 13 does not exist
errdisable recovery cause
!