Элтекс

Добрый день!
На канале L2vpn при тестировании анализатором выявлены проблемы с multicast трафиком, высокий показатель MLR. На оконечке установлен коммутатор MES2324, на физическом уровне потерь не выявлено. Может Элтекс влиять на MLR, и поможет в данном случае настройка qos и увеличение буферов выходных очередей?

Конфиг интерфейсов простейший
interface tengigabitethernet1/0/3
loopback-detection enable
description --downlink--
mtu 9000
rate-limit 2048000 burst 19173960
traffic-shape 2048000 16762902
switchport access vlan 3690
exit

interface tengigabitethernet1/0/4
description --UPLINK--
mtu 9000
switchport mode trunk
switchport trunk allowed vlan add 3439,3690
switchport forbidden default-vlan
exit

Здравствуйте.

Прошу включить
qos stat int
зафиксировать проблему с потерями и показать выводы
show ver
sh int te0/3
sh int te0/4

gdmnt-sw1#show ver
Active-image: flash://system/images/mes3300-4013-R1.ros
Version: 4.0.13
Commit: f0e0150c
Build: 1 (master)
MD5 Digest: 35e8f93c9b104239a39265afa81342f7
Date: 28-Aug-2019
Time: 17:07:22
Inactive-image: flash://system/images/_image1.bin
Version: 4.0.12
Commit: 1d69b051
Build: 183 (master)
MD5 Digest: 43b8f8f3caeda940a068af397d930183
Date: 04-Apr-2019
Time: 12:51:57

gdmnt-sw1#sh int te0/3
tengigabitethernet1/0/3 is up (connected)
Interface index is 107
Hardware is tengigabitethernet, MAC address is e0:d9:e3:12:d2:5b
Description: --DOWNLINK--
Interface MTU is 9000
Full-duplex, 10000Mbps, link type is 10000Mbps full-duplex, media type is 10G-Fiber
Link is up for 7 days, 2 hours, 12 minutes and 44 seconds
Flow control is off, MDIX mode is off
15 second input rate is 214 Kbit/s
15 second output rate is 866003 Kbit/s
422502 packets input, 231468469 bytes received
410 broadcasts, 153005 multicasts
73 input errors, 69 FCS, 0 alignment
0 oversize, 4 internal MAC
0 pause frames received
20068286589 packets output, 27554700469395 bytes sent
68 broadcasts, 20068012610 multicasts
0 output errors, 0 collisions
0 excessive collisions, 0 late collisions
0 pause frames transmitted
0 symbol errors, 0 carrier, 0 SQE test error
Output queues: (queue #: packets passed/packets dropped)
1: 6/0
2: 67277/0
3: 0/0
4: 0/0
5: 0/0
6: 157687565/0
7: 379/0
8: 0/0

gdmnt-sw1#sh int te0/4
tengigabitethernet1/0/4 is up (connected)
Interface index is 108
Hardware is tengigabitethernet, MAC address is e0:d9:e3:12:d2:5c
Description: --UPLINK--
Interface MTU is 9000
Full-duplex, 10000Mbps, link type is 10000Mbps full-duplex, media type is 10G-Fiber
Link is up for 7 days, 2 hours, 12 minutes and 59 seconds
Flow control is off, MDIX mode is off
15 second input rate is 868063 Kbit/s
15 second output rate is 192 Kbit/s
40230476189 packets input, 55397214423524 bytes received
2330 broadcasts, 40229213929 multicasts
0 input errors, 0 FCS, 0 alignment
0 oversize, 0 internal MAC
0 pause frames received
1610115 packets output, 1149577864 bytes sent
843 broadcasts, 325611 multicasts
0 output errors, 0 collisions
0 excessive collisions, 0 late collisions
0 pause frames transmitted
0 symbol errors, 0 carrier, 0 SQE test error
Output queues: (queue #: packets passed/packets dropped)
1: 4/0
2: 68033/0
3: 0/0
4: 0/0
5: 0/0
6: 0/0
7: 1478/0
8: 0/0

Здравствуйте.

Дропов в буферах нет, а вот ошибки есть на te0/3
gdmnt-sw1#sh int te0/3
73 input errors, 69 FCS, 0 alignment
Предположительно связаны с физикой.