С некоторых пор УЭП не может измерить входное напряжение. Перезагрузка модуля МК не решила данную проблему.
![Изображение](http://s7.hostingkartinok.com/uploads/thumbs/2014/08/a06973185cfee12a9269ac22e7aae486.png)
UEP operation parameters:
-------------------------
========= user set values ========
vset = 54.00 V - required battery voltage
iset = 10.0 A - max battery charge current
dv = 0.000 V/grad - battery voltage temperature coefficient
qcell = 4 - number of cells in each battery
qbat = 1 - number of batteries
inmax = 30.0 A - max load current
initcap = 75.0 A*h - initial battery capacity
dvcell = 0.200 V - battery cell voltage spread
========= measured values ========
i1 = 1.2 A - MP1 current
i2 = 1.7 A - MP2 current
i3 = 0.0 A - MP3 current
vbat = 54.00 V - battery voltage
ibat = 0.2 A - battery current
in = 3.1 A - load current
temp = -- - battery temperature control is off
acv = 0 V - AC voltage
wcap = 0.0 A*h - wasted battery capacity
t_dis = 0 min - battery discharge time
========= output values ========
vdac = 2428 units - MP control voltage
MP & relay state = 0x20:
MP1 is .............. on
MP2 is .............. on
MP3 is .............. on
K1 is ............... on
K2 is ............... off
Release device is ... on
Посоветуйте, как лучше поступить. Спасибо.