Изменять назначения порта inet или STB (iptv) с трудом, но у меня получилось (отключив TR-069). Более подробно по конфигурации:
Device Info / Summary
- Board type: NTP-RG-1402G-W:rev.C
- Board ID: 96818G_RG_REVC
- Hardware version: 1v10
- Software Version: 2.12.5.15
- Bootloader (CFE) Version: 1.0.38-114.-71
WAN service 0: veip0
- Interface: ppp0.1
- Type: PPPoE
- Connection type: IP_Routed
- NAT: Enabled
- Firewall: Enabled
- Bridging to: eth0.0,eth2.0,wl0
WAN service 1: veip1
- Interface: veip1.1
- Type: Bridge
- Connection type: IP_Bridged
- Status: Unconfigured
WAN service 2: veip2
- Interface: veip2.1
- Type: IPoE
- Connection type: IP_Routed
- Status: Connected
- Bridging to: eth0.0,eth2.0,wl0
WAN service 3: veip3
- Interface: veip3.1
- Type: Bridge
- Connection type: IP_Bridged
- Status: Connected
- IPv4 Address: 1.1.1.1
- Bridging to: eth1.0
WAN service 4: ipoe_veip4
- Interface: veip4.1
- Type: IPoE
- Connection type: IP_Routed
- Status: Connected
- Bridging to: eth0.0,eth2.0,wl0
WAN service 5: veip5
- Interface: veip5.1
- Type: Bridge
- Connection type: IP_Bridged
- Status: Unconfigured
WAN service 6: veip6
- Interface: veip6.1
- Type: Bridge
- Connection type: IP_Bridged
- Status: Unconfigured
WAN service 7: veip7
- Interface: veip7.1
- Type: Bridge
- Connection type: IP_Bridged
- Status: Unconfigured