Скорее всего я что-то недопонял в документации и не правильно делаю. Ногами не бейте
Eltex LTP-8X:rev.C software version 3.30.0 build 2931 on 28.11.2017 16:48
Мультикаст приходит на LTP8 во влан 101
IPoE в 300 влан
profile "NTU-RG"
...
set property "InternetGatewayDevice.WANDevice.1.WANConnectionDevice.1.WANIPConnection.1.X_BROADCOM_COM_IGMPEnabled" "TRUE" nocheck
set property "InternetGatewayDevice.X_BROADCOM_COM_IGMPCfg.IgmpVer" "2" nocheck
set property "InternetGatewayDevice.LANDevice.1.X_BROADCOM_COM_IgmpSnoopingConfig.Enable" "TRUE" nocheck
set property "InternetGatewayDevice.Layer2Bridging.Bridge.1.BridgeEnable" "TRUE" nocheck
set property "InternetGatewayDevice.Layer2Bridging.Bridge.1.BridgeName" "IPoE" nocheck
set property "InternetGatewayDevice.Layer2Bridging.Bridge.1.BridgeStandard" "802.1Q" nocheck
set property "InternetGatewayDevice.Layer2Bridging.Bridge.1.VLANID" "300" nocheck
set property "InternetGatewayDevice.Layer2Bridging.Bridge.2.BridgeEnable" "1" nocheck
set property "InternetGatewayDevice.Layer2Bridging.Bridge.2.BridgeName" "brVOIP" nocheck
set property "InternetGatewayDevice.Layer2Bridging.Bridge.2.BridgeStandard" "802.1Q" nocheck
set property "InternetGatewayDevice.Layer2Bridging.Bridge.2.VLANID" "300" nocheck
...
Проверялось вот на такой конфигурации:
!
profile cross-connect "ACS"
outer vid "4094"
type "management"
exit
!
profile cross-connect "INTERNET"
outer vid "300"
user vid "300"
exit
!
profile cross-connect "IPTV_101_300"
outer vid "101"
user vid "101"
type "multicast"
exit
!
profile ports "IPTV_101_300"
igmp multicast dynamic-entry 0 vid "101"
igmp multicast dynamic-entry 0 group "224.0.0.1" "239.255.255.254"
veip multicast
veip upstream vid "101"
veip downstream vid "101"
exit
!
template "INTERNET_IPTV"
service 0 profile cross-connect "INTERNET"
service 0 profile dba "dba-00"
service 1 profile cross-connect "IPTV_101_300"
service 1 profile dba "dba-00"
service 4 profile cross-connect "ACS"
service 4 profile dba "dba-00"
profile ports "IPTV_101_300"
exit
!
interface ont 0/1
serial "ELTX5C09F300"
template "INTERNET_IPTV"
exit
!
switch
configure
ip igmp snooping
ip igmp proxy report enable
ip igmp proxy report range 224.0.0.1 239.255.255.255 from 300 to 101
exit
vlan 101
name IPTV
tagged front-port 0-7
tagged 10G-front-port 0-1
tagged pon-port 0-7
ip igmp snooping querier enable
exit
vlan 300
name IPoE
tagged front-port 0-7
tagged 10G-front-port 0-1
tagged pon-port 0-7
exit
acs
ont
add ont "454C54585C09F300" profile="NTU-RG" hardware="NTU-RG-1402G-W" config="Default"
ont "454C54585C09F300"
exit
exit
user
add user "user_454C54585C09F300" pon_serial="454C54585C09F300"
....
счётчики show interface ont 0/1 counters multicast-subscriber-monitor растут а реально мультикаст не показывался
LTP-8X# show interface ont 0/1 counters multicast-subscriber-monitor
-----------------------------------
[ONT4/15] counters
-----------------------------------
## Counters for ports: 0 1 2 3 veip
1 Current multicast bandwidth 0 0 0 0 0
2 Join messages counter 0 0 0 0 14
3 Bandwidth exceeded counter 0 0 0 0 0
4 Number of active groups 0 0 0 0 1
Veip:
Group[0]:
Client IP address: 192.168.1.2
Destination IP address: 229.255.1.113
Source IP address: 0.0.0.0
Recent join time: 3
Vlan ID: 0
Actual bandwidth: 0
Опытным путём было выяснено, (что, если на коммутаторе подмешать мультикаст) что запросы от ONT продолжают идти во влан 300, хотелось что-бы мультикаст был на LTP8 (передавался транком на LTP8, а не коммутатором отрабатывался)
!
interface tengigabitethernet1/0/1
description LTP8
bridge multicast unregistered filtering
switchport trunk multicast-tv vlan 101 tagged
switchport mode trunk
switchport trunk allowed vlan add 300
selective-qinq list egress override_vlan 300 ingress_vlan 101
!