LTE-8x update

[Taur]

Здравствуйте, помогите пожалуйста. Взял железо LTE-8x пробовал обновить с 2.2 на 3.6, сделал все по инструкции. В результате имею:

__ __ _ _
| \/ | __ _ _ ____ _____| | |
| |\/| |/ _` | '__\ \ / / _ \ | |
| | | | (_| | | \ V / __/ | |
|_| |_|\__,_|_| \_/ \___|_|_|
_ _ ____ _
| | | | | __ ) ___ ___ | |_
| | | |___| _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
\___/ |____/ \___/ \___/ \__| ** LOADER **
** MARVELL BOARD: DB-98DX4122-48G LE (configured)
** Linux - LE/BE support
** vxWorks(elf) - LE/BE support


U-Boot 1.1.4 (Jul 18 2011 - 09:45:56) Marvell version: 3.4.9.7

U-Boot code: 01200000 -> 0128FFF0 BSS: -> 012A9324

Soc: 88F6281 A0 (DDR2)
CPU running @ 800Mhz L2 running @ 400Mhz
SysClock = 320Mhz , TClock = 166Mhz

DRAM CAS Latency = 5 tRP = 6 tRAS = 15 tRCD=6
DRAM CS[0] base 0x00000000 size 128MB
DRAM CS[1] base 0x08000000 size 128MB
DRAM Total size 256MB 16bit width
Enabled 4-bytes addressing support for SPI flash
[32768kB@f8000000] Flash: 32 MB
Addresses 27M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (27M - 19M): Done
*** Warning - bad CRC, using default environment


CPU : Marvell Feroceon (Rev 1)
Set ELTEX environment for 2x256 FLASH!

Streaming disabled
Write allocate disabled


USB 0: host mode
PEX 0: interface detected no Link.
Net: Allowed switch ports: 16 17 18 19 20 21 22 23
egiga0 [PRIME], port16, port17, port18, port19, port20, port21, port22, port23
Type "stop" in 3 sec, to stop autoboot
Time out
................................................................
................................................................
................................................................
................................................................
................................................................
................................................................
................................................................
................................................................

Un-Protected 1 sectors
## Booting image at f8200000 ...
Image Name: Linux-2.6.22.18
Created: 2013-07-30 6:09:51 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1252368 Bytes = 1.2 MB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... OK
Loading Kernel Image ... OK

Checking for Linux kernel endianess at 0xf8200040 = 0xe1a00000
Linux Kernel is LE

Starting kernel in LE mode ...
Uncompressing Linux.................................................................................... done, booting the kernel.
Linux version 2.6.22.18 (jenkins@xpon.eltex.loc) (gcc version 3.4.4 (release) (CodeSourcery ARM 2005q3-2)) #1 Tue Jul 30 13:09:40 NOVT 2013
CPU: ARM926EJ-S [56251311] revision 1 (ARMv5TE), cr=00053977
Machine: Feroceon-KW
DMA memory:
mv_high_memory_paddr 0x0f800000
mv_high_memory_paddr_top 0x10000000
mv_high_memory_vaddr 0xef800000
mv_high_memory_vaddr_top 0xf0000000
Using UBoot passing parameters structure
BoardID from uboot=10
Memory policy: ECC disabled, Data cache writeback
calling iotable_init. MEM_TABLE=
virt=0xef800000, phys=0x0f800000, lengh=0x00800000
virt=0xe0000000, phys=0xe8000000, lengh=0x08000000
virt=0xf1000000, phys=0xf1000000, lengh=0x00100000
virt=0xf8000000, phys=0xf8000000, lengh=0x01000000
virt=0xf4000000, phys=0xf4000000, lengh=0x04000000
virt=0xfb000000, phys=0xfb000000, lengh=0x00010000
virt=0xf2000000, phys=0xf2000000, lengh=0x00010000
Internal prestera id register = 0x000dd743
xCat revision = A1
CPU0: D VIVT write-back cache
CPU0: I cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets
CPU0: D cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets
Built 1 zonelists. Total pages: 62992
Kernel command line: init=/sbin/save root=/dev/ram0 rw initrd=0x2000000,0x1000000 console=ttyS0,115200 mtdparts=spi_flash:2M(u-boot),2M(kernel),4M(config),8M(reserved),16M(initrd),32M(data)
PID hash table entries: 1024 (order: 10, 4096 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 128MB 120MB 0MB 0MB = 248MB total
Memory: 232576KB available (2336K code, 213K data, 120K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16

CPU Interface
-------------
SDRAM_CS0 ....base 00000000, size 128MB
SDRAM_CS1 ....base 08000000, size 128MB
SDRAM_CS2 ....disable
SDRAM_CS3 ....disable
PEX0_MEM ....base e8000000, size 128MB
PEX0_IO ....base fc000000, size 1MB
INTER_REGS ....base f1000000, size 1MB
NFLASH_CS ....base d8000000, size 128MB
SPI_CS ....base f8000000, size 16MB
BOOT_ROM_CS ....no such
DEV_BOOTCS ....no such
CRYPT_ENG ....base fb000000, size 64KB
SAGE_UNIT ....base f4000000, size 64MB
DRAGONITE_DTCM ....base f2000000, size 64KB

Marvell Development Board (LSP Version KW_LSP_4.3.0.015)-- DB-98DX4122-48G Soc: 88F6281 A0 LE

Detected Tclk 166666667 and SysClk 320000000
Switch default target range: 0F800000..0F800FFF
Switch address window 0: base=00000E00 size=07FF0000
Switch address window 1: base=08000D00 size=07FF0000
Switch default target: UDID=000000D0 UDA=0F800000
Switch decoding windows init is done.
MV Buttons Device Load
PEX0 interface detected no Link.
PCI: bus0: Fast back to back transfers enabled
NET: Registered protocol family 2
Time: kw_clocksource clocksource has been installed.
IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
TCP established hash table entries: 8192 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
TCP reno registered
checking if image is initramfs...it isn't (no cpio magic); looks like an initrd
Freeing initrd memory: 16384K
RTC has been updated!!!
RTC registered
Use the XOR engines (acceleration) for enhancing the following functions:
o RAID 5 Xor calculation
o kernel memcpy
o kenrel memzero
Number of XOR engines to use: 2
MV Buttons Driver Load
io scheduler noop registered
io scheduler anticipatory registered (default)
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0xf1012000 (irq = 33) is a 16550A
serial8250.0: ttyS1 at MMIO 0xf1012100 (irq = 34) is a 16550A
RAMDISK driver initialized: 1 RAM disks of 32768K size 1024 blocksize
Loading Marvell Ethernet Driver:
o Uncached descriptors in DRAM
o DRAM SW cache-coherency
o Multi RX Queue support - 8 RX queues
o Multi TX Queue support - 8 TX Queues
o TCP segmentation offload enabled
o Receive checksum offload enabled
o Transmit checksum offload enabled
o Network Fast Processing (Routing) supported
o Driver ERROR statistics enabled
o Driver INFO statistics enabled
o Proc tool API enabled
o Rx descripors: q0=64 q1=64 q2=64 q3=64 q4=64 q5=64 q6=64 q7=64
o Tx descripors: q0=532 q1=532 q2=532 q3=532 q4=532 q5=532 q6=532 q7=532
o Loading network interface(s):
o eth0, ifindex = 1, GbE port = 0

Warning: Giga 1 is Powered Off

mvFpRuleDb (c0514000): 2048 entries, 8192 bytes
NFTL driver: nftlcore.c $Revision: 1.98 $, nftlmount.c $Revision: 1.41 $
Enabled 4-bytes addressing support for SPI flash (reg IFCONFIG=0x4315)

INFO: sflash_probe - Detected SFlash device 0 (size 33554432)
Base Address : 0xf4000000
Manufacturer ID : 0xc2
Device ID : 0x2019
Sector Size : 0x10000
Sector Number : 512
SPI Serial flash 0 detected @ 0xf4000000, 32768KB (512sec x 64KB)
Enabled 4-bytes addressing support for SPI flash (reg IFCONFIG=0x4315)

INFO: sflash_probe - Detected SFlash device 1 (size 33554432)
Base Address : 0xf4000000
Manufacturer ID : 0xc2
Device ID : 0x2019
Sector Size : 0x10000
Sector Number : 512
SPI Serial flash 1 detected @ 0xf4000000, 32768KB (512sec x 64KB)
6 cmdlinepart partitions found on MTD device spi_flash
Creating 6 MTD partitions on "spi_flash":
0x00000000-0x00200000 : "u-boot"
0x00200000-0x00400000 : "kernel"
0x00400000-0x00800000 : "config"
0x00800000-0x01000000 : "reserved"
0x01000000-0x02000000 : "initrd"
0x02000000-0x04000000 : "data"
Using Hamming 1-bit ECC for NAND device
No NAND device found!!!
mice: PS/2 mouse device common for all mice
i2c /dev entries driver
sdma: loaded
nf_conntrack version 0.5.0 (1984 buckets, 15872 max)
ip_tables: (C) 2000-2006 Netfilter Core Team
arp_tables: (C) 2002 David S. Miller
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
RAMDISK: Compressed image found at block 0
invalid compressed format (err=1)
VFS: Mounted root (ext2 filesystem).
Freeing init memory: 120K
Warning: unable to open an initial console.
Failed to execute /sbin/save. Attempting defaults...
Kernel panic - not syncing: No init found. Try passing init= option to kernel.

[АндрейБ]

Здравствуйте.
Просьба уточнить, обновление было произведено через WEB-интерфейс?
Сообщите адрес Вашей электронной почты или же телефон для связи.

[Taur]

Обновлял через CLI.

[Taur]

Огромное спасибо. Заработало.

[borcat]

Аналогичная проблема. Что делать нужно?

[АндрейБ]

Пишите на Bosenko@eltex.org
Попробуем оживить устройство.

[alk]

Тоже такая же ситуация. Как решить напишите на kapustin@izhteleport.ru

[Dirks G]

Ответил вам на почту.

[alk]

Помогло спасибо!